
Warning! Do not keep the control knob pushed for
more than 15 seconds.
If the burner does not light after 15 seconds, release the
control knob, turn it into off position and try to light the
burner again after minimum 1 minute.
Important! In the absence of electricity You can ignite the
burner without electrical device; in this case approach the
burner with a flame, push the relevant knob down and turn
it counter-clockwise to maximum gas release position.
If the burner accidentally goes out, turn the control
knob to the off position and try to light the burner
again after minimum 1 minute.
The spark generator can start automatically when
you switch on the mains, after installation or a power
cut. It is normal.
Turning the burner off
To put the flame out, turn the knob to the symbol .
Warning! Always turn the flame down or switch it
off before you remove the pans of the burner.
Operating electric zones
To switch on and increase the heat setting turn the knob
clockwise. To decrease the heat setting turn the knob
counter-clockwise. To switch off turn the knob to the 0.
When a cooking zone operates, it hums for a short
time. This is typical of all ceramic glass cooking
zones and does not show that the appliance operates in-
correctly.
Rapid hot plate
A red dot in the middle of the plate shows a rapid hot plate.
A rapid hot plate heats up faster than usual plates.
The red dot is painted on the surface and can come off
after some time. It does not have an effect on the per-
formance of the appliance.
The rapid hot plate can smoke and make an odour when
you use it for the first time. The smoke and an odour will
go off after a while.
Power indicator is activated when either of the zones are
turned on, and will stay on until the cooking zones are
switched off.
Examples of cooking applications
Heat
setting:
Use to:
1 Keeping warm
2 Gentle simmering
3 Simmering
4 Frying / browning
5 Bringing to the boil
6 Bringing to the boil / quick frying / deep-
frying
Helpful hints and tips
Energy savings
• If possible, always put the lids on the pans.
• When the liquid starts to boil, turn down the flame to
barely simmer the liquid.
Warning! Use pots and pans with bottom applicable
to the dimension of burner.
Do not use cooking vessels on the hotplate that overlap
its edges.
Burner Diameters of cookware
Semi-rapid 120 mm - 220 mm
Burner Diameters of cookware
Auxiliary 80 mm - 160 mm
Warning! Pots must not enter the control zone.
Make sure pots do not protrude over the edges of the
cooktop and that they are centrally positioned on the rings
in order to obtain lower gas consumption.
Do not place unstable or deformed pots on the rings.
8
Commenti su questo manuale