Zanussi ZGF782ITX Manuale Utente Scaricare il pdf (Pagina 6)

Electrical Requirements

Any permanent electrical installation must comply with the

latest I.E.E. Regulations and local Electricity Board regula-

tions. For your own safety this should be undertaken by a

qualified electrician, e.g. your local Electricity Board, or a

contractor who is on the roll of the National Inspection

Council for Electrical Installation Contracting (NICEIC).

The manufacturer declines any liability should these safety

measures not be observed.

This hob is designed to be connected to a 230 V 50 Hz AC

electrical supply.

Before switching on, make sure the electricity supply volt-

age is the same as that indicated on the hob rating plate.

The rating plate is located on the bottom of the hob.

The hob is supplied with a 3 core flexible supply cord in-

corporating a 3 amp plug fitted. In the event of having to

change the fuse, a 3 amp ASTA approved (BS 1362) fuse

must be used.

1 2

1 Green and Yellow

2 3 amp fuse

3 Brown

4 Cord clamp

5 Blue

Should the plug need to be replaced for any reason, the

wires in the mains lead are coloured in accordance with

the following code:

Green and Yellow - Earth

Blue - Neutral

Brown - Live

1. Connect the green and yellow (earth) wire to the ter-

minal in the plug which is marked with the letter 'E'

or the earth symbol

or coloured green and yel-

low.

2. Connect the blue (neutral) wire to the terminal in the

plug which is marked with the letter 'N' or coloured

black.

3. Connect the brown (live) wire to the terminal in the

plug which is marked with the letter 'L' or coloured

red.

Upon completion there must be no cut, or stray strands of

wire present and the cord clamp must be secure over the

outer sheath.

Important! A cut off plug inserted into a 13 amp socket is

a serious safety (shock) hazard. Ensure that the cut off

plug is disposed of safely.

Important! The replacement of electric cable must be

carried out exclusively by the service force centre or by

personnel with similar competencies, in accordance with

the current regulations.

Replacement of the connection cable

To replace the connection cable use only H05V2V2-F T90

or equivalent type. Make sure that the cable section is ap-

plicable to the voltage and the working temperature. The

yellow/green earth wire must be approximately 2 cm lon-

ger than the brown (or black) phase wire.

Building In

min. 55 mm

min. 650 mm

560 mm

min. 450 mm

30 mm

480 mm

min. 600 mm

10 mm

86 mm

3 mm

1 2 3 4 5 6 7 8 9 10 11 ... 15 16

Commenti su questo manuale

Nessun commento

Zanussi ZGF782ITX Manuale Utente Pagina 6

Commenti su questo manuale

Prodotti e manuali riguardandi Piani cottura Zanussi ZGF782ITX